Leslie Langnau's Blog – May 2010 Archive (2)

Why isn't rapid prototyping/additive manufacturing a larger industry?

One question that stuck out at the recent RAPID Show in Anaheim, Calif was; Why isn’t this show bigger with more exhibitors and more attendees? This industry is 20+ years old. When will it become large enough to fill a convention hall rather than a hotel ballroom?



In the last few years, we have seen the introduction of 3D printers small enough to fit on your desktop at prices that are less than $5000. Higher end…

Continue

Added by Leslie Langnau on May 25, 2010 at 4:00am — No Comments

We need to be more open to discuss why a design failed

Why did a design fail? This is one of my favorite subjects because it is so rich in information. On my LinkedIn site, there's a discussion starting on this subject. A Design World reader found a 40 min video presentation by Scott Berkun, former design engineer at Microsoft. (…
Continue

Added by Leslie Langnau on May 5, 2010 at 6:29am — No Comments

Members

© 2021   Created by Marshall Matheson.   Powered by

Badges  |  Report an Issue  |  Terms of Service