Hi,

I am intending to press my OD 400mm F51 bar (60mm thk) into a OD 476mm piece (30mm thk). I intend to press it after induction heating it first. Is it possible? Some claim that such a large OD will be difficult to press even though after induction heating. Plus, F51 is said to be a tougher material than most metals, since it is duplex stainless steel. I will be pressing it using a 2000T hydraulic press. Are there any calculations that I can do? Thank you in advance.

Views: 113

Reply to This

Members

© 2019   Created by Marshall Matheson.   Powered by

Badges  |  Report an Issue  |  Terms of Service